Micro mosfet II

Professionally made mosfet designed for airsoft electric guns (AEG). Device increases gun rate of fire and battery holds longer, than with basic wiring. SPECIFICATIONS: - Very small device dimension, it fits nearly everywhere - Devices without wires, you can use max. 1,5qmm (AWG16) power wires and 0,25qmm (AWG21) signal wires - suitable for service center, if you are not familiar with soldering to the circuit board, choose device with wiring and accessories. - Designed for spring up to M160 (equivalent for current 25A for duration 10s). For higher load please use Extreme mosfet - Specified for common batteries up to 17V (Ni-xx 8.4 - 12V, lipol 7.4 - 14.8V) - 5 wires connection - positive wire isn't connect into device - device size 15x7x5mm - No current consumption in the idle mode - No sparking on switch contacts - In auto fire mode piston stops in random position due the mechabox design - For right function is necessary to have a functional gearbox cut off lever, selector plate, reverse latch, trigger and trigger block, as it has the standard gearbox DEVICE INSTRUCTIONS: you can download installation manual in English here [PDF, 673.34 kB] PACKING: device, heat shrink tube and installation manual in English WARNING: Installation of this device leave to expert, who could solder and disassemble airsoft gun. Never user soldering gun!