Delta Armory EAGLE FREYA V2 ETU Unit

EAGLE ETU FREYA V2 programmable processor unit

This expert product description was prepared by the ANAREUS.cz expert team. All rights to this unique content are bound to the anareus.cz domain.Delta Armory EAGLE FREYA V2 is an advanced ETU processor unit designed for airsoft AEGs with a Version 2 gearbox. Electronic trigger control replaces conventional mechanical switching and provides fast trigger response, programmable firing modes, pre-cocking and Active Brake. The unit allows you to configure the AUTO selector position for standard fully automatic fire, SEMI, 3-round or 5-round Burst. It also offers a Binary mode, which fires a shot both when the trigger is pulled and released, an AUG mode and a Sniper mode. You can independently adjust trigger sensitivity across 5 levels and pre-cocking across 6 levels, which leaves the piston pre-tensioned after firing and significantly reduces the response time of the gun with the next trigger pull. Active Brake can be switched on or off depending on the gun configuration. EAGLE FREYA is the same type of ETU used by Delta Armory in its FREYA R15 Gen2 airsoft rifle series and supports powerful 11.1V Li-Pol and Li-Ion batteries.

Key features of the EAGLE ETU FREYA V2

EAGLE ETU FREYA programming modes

• AUTO position: AUTO / SEMI / Burst 3 / Burst 5
• SEMI mode: SEMI / Binary / AUG / Sniper
• Trigger sensitivity: 5 levels – 20 / 40 / 60 / 80 / 100%
• Pre-cocking: 6 levels
• Active Brake: On / off

Technical specifications

• Manufacturer: Delta Armory
• Model: EAGLE ETU FREYA V2
• Type: Programmable ETU processor unit
• Designed for: AEG
• Gearbox version: V2
• AUTO modes: AUTO / SEMI / Burst 3 / Burst 5
• SEMI modes: SEMI / Binary / AUG / Sniper
• Trigger sensitivity: 5 levels
• Pre-cocking: 6 levels
• Active Brake: Yes, switchable
• Battery support: 11.1V Li-Pol / Li-Ion
• Connector type: T-Dean
• Wiring: Rear
• Used in guns: Delta Armory FREYA R15 Gen2

Package contents

• Delta Armory EAGLE FREYA V2 processor unit

Warning

• The ETU unit must be calibrated before first use.
• Set the selector to SAFE, connect the battery, then press and hold the trigger for 5 seconds until you hear two beeps.

Frequently Asked Questions (FAQ)

What can be adjusted on the EAGLE FREYA V2?

The unit allows you to adjust firing modes, trigger sensitivity, pre-cocking level and switch Active Brake on or off. This makes it possible to significantly customise the AEG's behaviour to suit its intended use.

What does Binary mode mean?

In Binary mode, one shot is fired when the trigger is pulled and another when it is released. This allows for a very high rate of fire without using fully automatic mode.

What is pre-cocking used for?

Pre-cocking leaves the piston pre-tensioned in a ready position after firing. When the trigger is pulled again, the motor therefore does not have to complete the entire working cycle before the shot is fired, significantly improving AEG trigger response.