PERUN V2 Lightning ETU Unit – Wiring to the Stock

Perun V2 Lightning ETU unit with lightning-fast response

This expert product description was prepared by the ANAREUS.cz expert team. All rights to this unique content are bound to the domain anareus.cz.

Perun V2 Lightning is a modern ETU unit that replaces traditional mechanical contacts in a V2 gearbox and takes your rifle performance to a whole new level. Thanks to optical and magnetic sensors, there is no contact burning or mechanical wear. Trigger response is instant, operation is consistent and the whole system is better protected against short circuits and overheating. The unit supports a wide range of settings, from trigger sensitivity to pre-cocking, active brake and DMR mode. For an even better shooting feel, we recommend adding trigger modules Clicker V2, Clicker V2 PRO or the fast Speeder V2. Installation is intended for Version 2 gearboxes. This version comes with rear wiring and a pre-soldered T-Deans connector, ready for standard Li-Pol and Li-Ion batteries (including LiHV). Installation requires advanced technical skills, if you are unsure, contact one of our partner service centers for assistance.

Key features of Perun V2 Lightning

Compatibility

• Gearbox: V2 Tokyo Marui standard
• Fits without modification: APS Silver Edge, A&K, Bolt, Delta Armory, Double Bell, Double Eagle, E&C, Evolution, G&G, G&P, Golden Eagle, ICS, JG, King Arms, KWA Gen 2.0, LCT, Lonex, Mancraft, Retro Arms, S&T, Specna Arms Orion, SA One, SA Aether, SA Core, Tokyo Marui, Ultimate, Valken, VFC and others
• Minor modification required: CYMA (light sanding in contact area)
• Not compatible: Classic Army ECS, Ares EFCS, KWA ERG, G&G ETU triggers

Technical specifications

• Supported voltage: 7 V – 17 V
• Supported batteries: Li-Pol, Li-Ion
• Supported motors: Standard brushed and BLDC brushless motors
• Supported modules: Clicker V2, Clicker V2 PRO, Speeder V2
• Connector: T-Plug (T-Deans)
• Programming: Via trigger and fire selector
• Li-Pol alarm: 3.7 V per cell
• Diagnostics and protection: Short circuit, gearbox jam, overheating protection, magnetic field detection, LED error indication

Important notes

• Always disconnect the battery after use, the unit draws small standby current.
• Do not use batteries above 17 V, permanent damage may occur.
• After using pre-cocking, release the spring by switching to SEMI and holding the trigger for about 3 seconds.
• During installation, ensure proper wire routing to prevent damage.
• Czech manual
• English manual

Package contents

• Perun V2 Lightning ETU unit
• Rear wiring with T-Deans connector (pre-soldered)
• Installation and user manual